![]() It was bang on – This is to be expected these days, if your extruder values are way off the theoretical values during a basic extruder test then check your maths and the assembly to make sure nothing is obviously wrong. I.e marked the filament at 100mm from the top of the bowden coupling and extruded 100mm then checked where the mark was relative to that point. I performed the usual extrusion calibration check. I then took apart the old carriage assembly and popped in the new one and I have got to say the black casing perfectly matches my colour scheme. Retraction speed: 60mm/s(24V power supply), 30mm/s (12V power supply).Retraction: 1.2mm (for the volcano V6 hotend). ![]()
0 Comments
Leave a Reply. |